EPad Setup Overview

Before using EPad:

• Connect the EPad Signature Capture device to the terminal at your sales counter.

• Install the Eclipse Electronic Signature Capture application.

• If you do not already have the Document Imaging companion product, obtain and install it.

• If you want to print or fax invoices with attached signatures, install the required code with Document Imaging.

• If you want to e-mail or fax invoices with attached signatures, obtain Outbound E-mail and VSI-FAX, if necessary.

Note: Your Eclipse installer should perform the above setup tasks. If these setup tasks were not completed with your initial installation, contact Eclipse Advance Technical support.

After all components are installed, you must set up your Eclipse system, along with the EPad Signature Capture devices that will be used for collecting signatures. Define the following:

• Control and authorization parameters on the Eclipse system.

• Document Imaging parameters on the Eclipse system.

• EPad preferences.

See Also:

EPad Overview

Setup Requirements for EPad

EPad Preferences

Setting Up Host EPad Preferences

Setting Up EPad Preferences by Branch

Setting Up EPad Preferences by POS Location

Signature Capture and Document Imaging Guidelines